Skip to content

Cadence Engineer Interview Questions

For engineers who develop electronic circuits and devices. Interviews focus on weighing design options, testing equipment and guiding assembly.

30 questions, ranked by what the job needs most

Print the top 10:Scoring sheetPractice sheet

  1. Question 1: How would you design the input circuit for a sensor whose small signal must be measured near a noisy power circuit?

  2. Question 2: Walk me through a time you traced a mismatch between a circuit simulation and bench measurements to the simulation setup.

  3. Question 3: Describe a time your review caught an interface mismatch between electronic subsystems before they were connected.

  4. Question 4: What factors do you weigh when deciding whether a proposed electronic product or system is feasible to build?

  5. Question 5: Tell me about a time you debugged a circuit board or electronic device that was not working as designed.

  6. Question 6: Tell me about a time you weighed the strengths and weaknesses of two design approaches for a circuit or system before choosing one.

  7. Question 7: Tell me about a time you helped a customer resolve conflicting requirements for an electronic product.

  8. Question 8: What would you recommend if an electronic unit met its performance requirements on the bench but overheated in its intended enclosure?

  9. Question 9: How have you kept electronics projects on track to meet applicable regulations and standards from design through release?

  10. Question 10: Share an example of how you coordinated an electronic equipment installation when several teams needed access to the same equipment.

  11. Question 11: Describe a time you made your design requirements clear to technicians or a manufacturer building or modifying electronic equipment you designed.

  12. Question 12: Describe a time you documented a product performance limit that others needed to understand before an electronics design could move forward.

  13. Question 13: Talk about a time your analysis showed that an electronic system could not meet a customer's requested capacity.

  14. Question 14: Give an example of how you helped a technician understand an equipment standard they had misinterpreted.

  15. Question 15: How do you determine the components and test equipment needed to build and verify an electronic prototype?

  16. Question 16: Describe an effective procedure you developed for the operation, maintenance, or testing of a product.

  17. Question 17: Provide an effective method you have used to ensure that equipment and systems conform to specifications, standards, and regulations.

  18. Question 18: Describe an application or modification you planned or developed for electronic properties which effectively improved technical performance of a component, product, or system.

  19. Question 19: What is the state of your documentation? What is one thing you would like to improve?

  20. Question 20: Share an experience in which you successfully prepared necessary criteria, procedures, reports, or plans for successful conduct of a project.

  21. Question 21: Share an experience in which you effectively applied principles of electronic theory to an engineering project.

  22. Question 22: Describe an effective sketch you prepared. How about one that was not as effective?

  23. Question 23: Provide an experience in which your recommendation for the modification of a design benefited your company.

  24. Question 24: Share an experience in which you assisted a staff member or customer in a difficult in-service engineering problem.

  25. Question 25: Provide an experience in which you evaluated the work of others. How did you ensure effectiveness and adequate resolutions of complex engineering problems?

  26. Question 26: Share an experience in which conferring with others helped you in your work.

  27. Question 27: What factors do you consider when determining material and equipment needs?

  28. Question 28: Share an experience in which you prepared an effective budget or cost estimates.

  29. Question 29: Tell me about a time you had to tell a manager or customer that a design failed testing or would miss its date.

  30. Question 30: Walk me through a time you improved an electronics project by using a new component, design tool or technique.