Skip to content

Bulk Coolers Installer Interview Questions

For mechanics who install and repair commercial and industrial refrigeration systems. Interviews focus on reading system drawings, charging systems and recovering refrigerant.

30 questions, ranked by what the job needs most

Print the top 10:Scoring sheetPractice sheet

  1. Question 1: Walk me through charging a refrigeration system to its specifications, including any valve settings its procedure requires.

  2. Question 2: How do you choose a safe test pressure when checking refrigeration piping for leaks?

  3. Question 3: How do you keep the inside of refrigeration tubing clean while brazing a repair joint?

  4. Question 4: How do you safely test a refrigeration control circuit for continuity?

  5. Question 5: Describe a time you repaired damaged refrigeration wiring that would have failed again if you had only replaced the wire.

  6. Question 6: Describe a time you brazed or soldered a leaking joint in a commercial refrigeration system.

  7. Question 7: Share an example of how a customer's description helped you narrow down an intermittent refrigeration problem.

  8. Question 8: Describe a time you repaired a compressor, fan motor or other mechanical part on a refrigeration system.

  9. Question 9: What's the hardest part of using gauges and other instruments to tell whether a commercial refrigeration system is running properly?

  10. Question 10: Tell me about a time a close inspection of a refrigeration system helped you find the cause of a problem.

  11. Question 11: Tell me about a time you combined what a customer told you, your readings and the service manual to find a fault.

  12. Question 12: What would you do if you noticed refrigerant escaping into an enclosed equipment room while preparing to service a system?

  13. Question 13: Walk me through a preventive maintenance visit on a commercial refrigeration system, including how you decide what it needs.

  14. Question 14: Tell me about a time you found a mismatch between a refrigeration control wiring diagram and the wires at the unit.

  15. Question 15: Walk me through a time you corrected a defrost timer setup that was causing trouble in a freezer.

  16. Question 16: Recall a situation where you corrected refrigeration control settings that were making the system cycle poorly.

  17. Question 17: Describe your role in a refrigeration system overhaul where the used refrigerant was sent for reclamation.

  18. Question 18: How should recovered refrigerant be handled when you suspect it is mixed with another refrigerant?

  19. Question 19: Tell me about a time you spotted a problem in a system's pressures, temperatures or service records before it caused a breakdown.

  20. Question 20: Walk me through how you read blueprints and specifications to plan a refrigeration installation.

  21. Question 21: Describe a time you found that a newly installed refrigeration system did not meet its specified performance during testing.

  22. Question 22: Tell me how you handled a difficult refrigeration installation.

  23. Question 23: Describe a time you resolved a conflict between a refrigeration installation drawing and the manufacturer's required service clearance.

  24. Question 24: How do you protect a new refrigeration expansion valve from damage during installation?

  25. Question 25: Tell me about a time you found contamination before connecting refrigerant lines to refrigeration equipment.

  26. Question 26: Tell me about the last time you mounted compressor, condenser, and other components in specified locations on frames, using hand tools and acetylene welding equipment.

  27. Question 27: What do you check before tightening a refrigeration compressor onto its mounting frame?

  28. Question 28: What kind of experience do you have cutting, bending, threading, and connecting pipe to functional components and water, power, or refrigeration system?

  29. Question 29: How do you prepare and bend refrigeration tubing without restricting the bore or leaving debris inside?

  30. Question 30: Walk me through a time you caught a measurement error while marking locations for refrigeration equipment.