Skip to content

Master Plumber Interview Questions

For plumbers working across water, heating and drainage systems in buildings. Interviews focus on reading plans, laying out pipe routes and cutting and shaping pipe.

30 questions, ranked by what the job needs most

Print the top 10:Scoring sheetPractice sheet

  1. Question 1: When you review the plans for a drain installation, what do you check against the plumbing code and job specifications?

  2. Question 2: How do you prepare a length of pipe to fit the measurements for a plumbing installation?

  3. Question 3: Walk me through a pressure test you used to track down a leak in a plumbing line.

  4. Question 4: How do you install a shutoff valve on a water supply line?

  5. Question 5: Walk me through a time you cleared a drain blockage that returned after an earlier repair.

  6. Question 6: How do you use the building plans and a site walk to lay out a pipe run around existing wiring?

  7. Question 7: How do you mark pipe routes and fixture locations before a plumbing installation?

  8. Question 8: Walk me through assembling a solvent-welded plastic pipe joint.

  9. Question 9: Describe a time you had to maintain the required slope on an underground drain run despite difficult site conditions.

  10. Question 10: Describe a time you had to find a suitable substitute for a specified pipe or fitting.

  11. Question 11: Share an example from work or training of how you checked a full-size pipe layout against a blueprint before assembly.

  12. Question 12: How do you check an installed drain line before calling for its final inspection?

  13. Question 13: Name a time when you directed helpers engaged in pipe cutting, preassembly, or installation of plumbing systems or components.

  14. Question 14: What would you do if the planned opening for a drain pipe would cut through a floor joist?

  15. Question 15: How do you install steel pipe supports from ceiling joists?

  16. Question 16: Tell me about a time you secured a wall-mounted pipe that moved when a fixture was used.

  17. Question 17: Describe a time you replaced a plumbing valve while keeping a building's water outage as short as possible.

  18. Question 18: How do you safely flush sediment from a water heater?

  19. Question 19: Give an example of how you fixed a water-pressure problem by installing a pressure-reducing valve.

  20. Question 20: What do you record about an unfinished plumbing assignment so another plumber can continue the work?

  21. Question 21: Tell me how you handled a shutoff valve that did not fully stop the water before a pipe repair.

  22. Question 22: Tell me about a time you used plumbing symptoms and test results to choose a repair.

  23. Question 23: Describe a time a small detail you noticed prevented a plumbing installation error.

  24. Question 24: Share an example of following through on a plumbing repair commitment when the job became harder than expected.

  25. Question 25: How do you prioritize plumbing service calls when several customers need work the same day?

  26. Question 26: What is the most challenging part of preparing written work cost estimates and negotiating contracts?

  27. Question 27: What kind of experience do you have performing complex calculations and planning for special or very large jobs? Share an example.

  28. Question 28: Describe a time you faced pressure to cut corners on a plumbing job to save money.

  29. Question 29: Tell me about a time a change in a plumbing system's pressure or flow alerted you to a problem.

  30. Question 30: Share an example of learning to operate a pipe-threading or pipe-bending machine for a plumbing job.