Skip to content

Health Inspector Interview Questions

For environmental compliance inspectors who investigate pollution at facilities. Interviews focus on checking permits, sampling wastewater and writing inspection reports.

30 questions, ranked by what the job needs most

Also for Health Inspector: Agricultural Inspectors · compare them →

Print the top 10:Scoring sheetPractice sheet

  1. Question 1: Walk me through what you check to verify that a facility handles, stores and disposes of hazardous chemicals according to regulations.

  2. Question 2: Walk me through how you decided what to do about a permit violation you found during an environmental inspection.

  3. Question 3: Tell me how you investigated a complaint about a suspected discharge from an industrial site.

  4. Question 4: Share an example of how you resolved a mismatch between a facility's environmental permit and the activities shown in its operating records.

  5. Question 5: When a state or federal pretreatment or stormwater rule changes, how do you work out what it means for the permits and programs you oversee?

  6. Question 6: Describe a time you worked with another government agency to decide which pollution reports needed a site visit.

  7. Question 7: Share an example of how you interviewed a facility employee to gather evidence about a suspected waste storage violation.

  8. Question 8: Give an example of how you explained a stormwater problem to a site operator to get it fixed.

  9. Question 9: What would you do if a facility reported that an environmental violation was corrected but supplied no evidence of the work?

  10. Question 10: Recall a time when following a site safety procedure helped you avoid a hazard during an industrial waste inspection.

  11. Question 11: What factors do you consider when determining sampling locations and methods? Share an experience in which you were effective.

  12. Question 12: Describe a time you recorded field conditions that helped explain a flow meter reading or chemical level during an environmental inspection.

  13. Question 13: Share an experience in which you effectively prepared reports summarizing requirements and regulations.

  14. Question 14: Walk me through how you inspect a wastewater treatment or waste disposal facility for compliance with its permit and regulations.

  15. Question 15: How do you plan and prioritize your inspections when routine site visits, complaint investigations and follow-ups are all due in the same week?

  16. Question 16: Describe an investigation where you had to weigh site records, interviews and sample results to decide which evidence was relevant.

  17. Question 17: Tell me about a time you reviewed a facility's monitoring reports or field data and spotted a compliance problem.

  18. Question 18: Walk me through how you followed up when a facility missed the deadline for corrective actions after a violation.

  19. Question 19: Provide an example when your ethics were tested.

  20. Question 20: Tell me about a time a change in EPA or state environmental rules changed how you inspected a facility or enforced a requirement.

  21. Question 21: What is the state of your inspection records? What is one thing you would like to improve?

  22. Question 22: Tell me about a time you found a spill or hazardous waste risk at a site and recommended corrective actions to prevent a release.

  23. Question 23: Name a time when you identified strengths and weaknesses of alternative solutions to problems. What was the impact?

  24. Question 24: Provide a time when you dealt calmly and effectively with a high-stress situation.

  25. Question 25: Name a time when your patience was tested. How did you keep your emotions in check?

  26. Question 26: Share a time when you successfully used scientific rules or methods to solve a problem at work.

  27. Question 27: Walk me through how you check whether a facility's discharge stays within its permit limits, such as daily volume or wastewater strength.

  28. Question 28: Tell me about a time you had to explain a water contamination risk to property owners or members of the public.

  29. Question 29: Walk me through how you check a pesticide or chemical product label for accuracy and compliance with regulatory requirements.

  30. Question 30: Share how you would review and evaluate applications for registration of products containing dangerous materials, or for pollution control discharge permits.