Skip to content

Engineer Interview Questions

For marine engineers who design ship propulsion and power systems. Interviews focus on inspecting machinery, writing equipment specifications and overseeing installation.

30 questions, ranked by what the job needs most

In other fields: Chemical Engineers · Construction and Building Inspectors · Electronics Engineers · all 19 sets →

Engineer in 18 other fields →

Print the top 10:Scoring sheetPractice sheet

  1. Question 1: Walk me through how you turned an inspection finding on a ship's machinery into a work request or job specification.

  2. Question 2: Tell me about a time you reconciled a vessel owner's speed requirement with limits on draft or displacement.

  3. Question 3: How do you check that an engine room arrangement leaves enough space to remove major machinery for maintenance?

  4. Question 4: Describe a time you revised a hull or superstructure design after test data showed it would miss a performance target.

  5. Question 5: What would you do if a proposed deck-mounted crane put a vessel outside its approved stability limits?

  6. Question 6: In your experience, what is the key to making sure a vessel design or repair meets classification society and flag state rules?

  7. Question 7: What would you do if a vessel's pollution prevention equipment passed its self-test but its required inspection record was missing?

  8. Question 8: How have you traced a recurring false alarm in a shipboard control system?

  9. Question 9: Tell me about a time you oversaw the installation or modification of shipboard equipment and had to make the specifications clear to the people doing the work.

  10. Question 10: How do you keep a shipboard piping schematic consistent with its layout drawings through design revisions?

  11. Question 11: Tell me about a shipboard equipment installation you had to change because the vessel differed from the design drawings.

  12. Question 12: Recall a time you withheld acceptance of marine equipment because it failed a test requirement.

  13. Question 13: What would you do if a ship met its trial speed only at a lighter displacement than the contract specified?

  14. Question 14: Walk me through how you analyzed data from a sea trial, a test or a machinery monitoring system to reach an engineering conclusion.

  15. Question 15: What would you do if a shipyard proposed a cheaper repair that differed from the repair plan accepted by the classification society?

  16. Question 16: Tell me about a time you had to choose between repairing and replacing a piece of shipboard machinery based on its costs and benefits.

  17. Question 17: Share an example of a vessel interior layout you changed to resolve a conflict between cargo space and access between decks.

  18. Question 18: Give an example of how you got a contractor to explain a cost increase left out of their vessel project progress report.

  19. Question 19: Give an example of how you handled an unclear scope item before pricing a ship construction or refit contract.

  20. Question 20: What would you do if corrosion found during a machinery inspection extended beyond the area covered by a shipyard work request?

  21. Question 21: Describe a time you checked whether findings from a marine equipment study still applied to a different vessel.

  22. Question 22: Describe a time you revised a marine engineering report because its intended readers misunderstood a technical finding.

  23. Question 23: Describe a marine machinery test you repeated after finding a problem with the test setup.

  24. Question 24: What would make you reject a marine equipment proposal even if its predicted fuel savings looked attractive?

  25. Question 25: How do you set stop limits before a staged load test of shipboard machinery?

  26. Question 26: What would you do if a machinery test certificate listed a different serial number from the unit being installed on a vessel?

  27. Question 27: Share an example of how you resolved a disagreement with research staff about using marine equipment study results in a design.

  28. Question 28: Walk me through a time a low ship repair estimate left out work that appeared in records of similar repairs.

  29. Question 29: Describe an effective product or system layout, detailed drawing, and schematic which you prepared.

  30. Question 30: Provide a time when you successfully designed and/or directed testing, installation, and repair of marine equipment.