Skip to content

CAD Technician (Computer Aided Drafting Technician) Interview Questions

For electrical drafters who prepare plans for power distribution. Interviews focus on drawing cable and transformer layouts and writing instructions for installation crews.

30 questions, ranked by what the job needs most

Print the top 10:Scoring sheetPractice sheet

  1. Question 1: Describe a time you turned an electrical assembly design into detail drawings that made the parts fit together correctly.

  2. Question 2: Walk me through how you prepare a wiring diagram or cable layout that gives an installation crew clear instructions.

  3. Question 3: What tools have you used to draw overhead or underground cable routes, on a computer or at a drafting table?

  4. Question 4: Share an example of how you resolved conflicting wire or cable labels while preparing an installation drawing.

  5. Question 5: What do you check before sending an electrical drawing set and its supporting documents to an engineer for review?

  6. Question 6: Walk me through a time you found a mismatch between an electrical construction drawing and its cost estimate.

  7. Question 7: What information do you need from an engineer before preparing a detailed drawing of an electrical cable termination?

  8. Question 8: Tell me about a time you worked with engineering staff to solve a clearance problem in an electrical equipment layout.

  9. Question 9: Give an example of how you measured a wire or cable route that was difficult to access.

  10. Question 10: How do you place a proposed electrical installation on a scaled master sketch of an existing facility?

  11. Question 11: Talk about a time you adjusted a lighting system design to suit the way a space would be used.

  12. Question 12: Describe a time a vendor's equipment drawing did not match the electrical work order you were drafting from.

  13. Question 13: How do you make sure you open the current revision of an electrical project's drawing from the drawing library?

  14. Question 14: What do you compare between an electronic schematic and its supporting documents before entering component dimensions or tolerances in a drawing?

  15. Question 15: Share an example of how you worked with an assembler to choose a conductor path that met a customer's drawing requirements.

  16. Question 16: Tell me about a time you clarified the type of electrical service an installation work order required.

  17. Question 17: What would you do if a construction crew asked you to change an electrical drawing to show a connection they had already installed differently?

  18. Question 18: How do you check that a logic element you modify on screen still matches the intended function in the engineering schematic?

  19. Question 19: Recall a time an electrical drawing lost lines or labels when you reproduced it for a working set.

  20. Question 20: Tell me about a successful documentation package you assembled or an effective drawing set you produced.

  21. Question 21: Share an effective method you have used to measure factors that affect installation and arrangement of equipment.

  22. Question 22: How do you ensure that construction drawings and cost estimates are accurate and conform to standards and regulations?

  23. Question 23: Share an effective method you have used to prepare and interpret specifications.

  24. Question 24: Share an experience in which conferring with personnel helped you to resolve a difficult problem.

  25. Question 25: Share an experience in which you successfully explained a drawing to a production or construction team.

  26. Question 26: Provide an effective method you have used to draw sketches of installation sites.

  27. Question 27: Tell me about a time you caught an error in an electrical drawing or schematic before it went out for construction.

  28. Question 28: How do you make sure your electrical drawings meet the applicable electrical codes, utility requirements and your company's drafting standards?

  29. Question 29: Describe a time careful listening helped you understand an engineer's spoken instructions for an electrical drawing.

  30. Question 30: Walk me through how you clarified one of your electrical drawings after an assembler or installer misread it.