Skip to content

Air Valve Mechanic Interview Questions

For mechanics who install and service valves, meters and regulators. Interviews focus on replacing worn meter parts, checking gas regulator installations and repairing mechanical controls.

28 questions, ranked by what the job needs most

Print the top 10:Scoring sheetPractice sheet

  1. Question 1: Tell me about a control valve you took apart to fix a stem that was sticking.

  2. Question 2: How do you install a gas pressure regulator at a meter so you know it works before you put it into service?

  3. Question 3: Share an example of a time you documented an unfinished valve or regulator repair for the next technician.

  4. Question 4: Walk me through a bench inspection of valve parts for visible damage or loose attachments.

  5. Question 5: How do you keep up with changes in the way gas regulators are tested for leaks and accurate pressure settings?

  6. Question 6: Give an example of a problem you caught by taking a closer look at an installed water meter.

  7. Question 7: How do you measure a used valve stem and its guide to decide if the pair is within spec for reuse?

  8. Question 8: What would you do if you were asked to lubricate an oxygen-service regulator with oil that had no oxygen-service rating?

  9. Question 9: Walk me through replacing a worn gear in the register of a mechanical water meter.

  10. Question 10: Describe a time you used an assembly drawing to put a gas regulator back together after replacing a damaged spring.

  11. Question 11: Tell me about a time you advised a customer or contractor on how to install a valve or regulator correctly.

  12. Question 12: Share an experience in which your attention to detail and thoroughness had an impact on your last company.

  13. Question 13: Share an example of when you went above and beyond the "call of duty".

  14. Question 14: What is the most challenging part of shutting off service and notify repair crews when major repairs are required, such as the replacement of underground pipes or wiring? Share an example.

  15. Question 15: Tell me about a time you had to give your supervisor or crew bad news about a meter, regulator or valve test.

  16. Question 16: Provide an example when your ethics were tested.

  17. Question 17: Describe a recent job where you had to move and fit a heavy meter, regulator or valve body into place by hand.

  18. Question 18: Tell me about a time when you successfully determined the cause of an operating error at your company and solved the problem.

  19. Question 19: Share an experience in which you conducted a test of a product, service, or process and successfully improved the quality or performance.

  20. Question 20: Tell me about your last experience doing repair work. How did you determine what tools you needed?

  21. Question 21: Tell me about the last time you performed routine maintenance on equipment. How did you determine when and what type of work was needed?

  22. Question 22: Describe a time when you successfully serviced, repaired, calibrated, or tested a device that operates mainly by electronic principles.

  23. Question 23: Tell me about the last time you monitored or reviewed information and detected a problem. How did you respond?

  24. Question 24: Describe an experience in which you successfully controlled the operation of a difficult system. What made you successful?

  25. Question 25: Describe a time you improved a valve installation or repair by learning to use a new meter or digital pressure tester.

  26. Question 26: Describe an experience where you had to investigate instances of illegal tapping into service lines.

  27. Question 27: What system would you use to recommend and write up specifications for changes in hardware, such as house wiring? Why?

  28. Question 28: Share an experience where you had to collect money due on delinquent accounts. What method did you find most helpful?