Skip to content

Custom Stock Maker Interview Questions

For cabinetmakers and bench carpenters in woodworking shops. Interviews focus on reading plans, setting up woodworking machines and assembling cabinets, fixtures or furniture.

30 questions, ranked by what the job needs most

Print the top 10:Scoring sheetPractice sheet

  1. Question 1: How do you check that parts match the drawings and will fit together before they go to assembly?

  2. Question 2: Describe a cabinet project where you planned the cutting and assembly from shop drawings or customer instructions.

  3. Question 3: Walk me through your part in building a cabinet or store fixture in the shop.

  4. Question 4: Walk me through how you set up a shaper or molder for a new profile, from choosing the cutter to running the first good part.

  5. Question 5: Walk me through the last time you measured and marked cabinet parts from a blueprint before cutting.

  6. Question 6: How do you keep a cabinet rail's tenon shoulders square when cutting them with a hand saw?

  7. Question 7: How do you control hole location and depth when drilling cabinet parts for dowels?

  8. Question 8: Walk me through a cabinet glue-up where the parts shifted as you tightened the clamps.

  9. Question 9: How do you match the wood for cabinet doors that will sit side by side?

  10. Question 10: Share an example of how you removed tear-out or machine marks from cabinet parts before finishing.

  11. Question 11: Tell me about a time a cabinet door rubbed or sat unevenly after you installed its hinges.

  12. Question 12: How do you choose fastener length and placement when reinforcing a cabinet joint before finishing?

  13. Question 13: How do you use fine sandpaper to touch up a small scratch near a crisp cabinet edge without rounding it?

  14. Question 14: Tell me about a time a small detail you noticed, such as reversed grain or an off measurement, saved a piece from being remade.

  15. Question 15: Tell me about a time you caught a problem in your stock or a machine setup before it ruined a run of parts.

  16. Question 16: Tell me about a time you went beyond your usual shop responsibilities to help get a cabinet order completed correctly.

  17. Question 17: Tell me about a time you programmed a CNC router to make cabinet parts.

  18. Question 18: Walk me through how you have used CAD or cabinet design software to design a piece of furniture or a set of cabinets.

  19. Question 19: Walk me through how you estimate the lumber, sheet goods, and hardware for a set of kitchen cabinets.

  20. Question 20: Share an example of how you repaired a wooden chair you found had a cracked rail rather than just a loose joint.

  21. Question 21: Tell me how you handled a difficult customer request while drawing up specifications for a cabinet or piece of furniture.

  22. Question 22: Tell me about a recent job where you had to fit or adjust a part by hand to get it right.

  23. Question 23: What work habits help you maintain stamina for the physical tasks in a cabinet shop?

  24. Question 24: Tell me about a time a saw, jointer, or other shop machine started making bad cuts and you tracked down the cause.

  25. Question 25: Describe a time when you were able to select the best tool to do a job. How did you use reasoning skills to make the best choice?

  26. Question 26: Describe an experience in which you successfully controlled the operation of a difficult system. What made you successful?

  27. Question 27: Tell me about the last time you performed routine maintenance on equipment. How did you determine when and what type of work was needed?

  28. Question 28: Share an experience in which you conducted a test of a product, service, or process and successfully improved the quality or performance.

  29. Question 29: Tell me how you organize, plan, and prioritize your work.

  30. Question 30: Provide an experience that demonstrates your ability to manage time effectively. What were the challenges and results?